This module allows you to drive  the Midi decoder 32-output board,   especially to check  all coils connected to the outputs,  to facilitate the tuning of pipes, test pneumatic valves, etc …

You can install it permanently on your organ at your fingertips, it will be useful very often.

• Check outputs one by one (without going through the Midi)
• Keep your hands free to tune your pipes  quietly.
• Check the speed of your pneumatic relay valves with the “repeat mode”.
• Quick check of all notes at any time with the “sequence” mode.

Instructions manual:Midi assistant 32

standard fuse 5*20.
Comes with 8 * 500mA fuses.
88 mm long, 50 mm wide.
Can be used to protect 8 groupes of solenoids. In that case, choose correct value for fuses.

To “distribute” the Midi flow to up to 4 boards, allowing them to receive data without latency.

Available in 3 versions:

• Complete : with all cables to connect to other boards. Midi wire and socket + power line cable.
• Minimum: the components are already soldered on board,  you just will need to solder your cables on the board to connect other midi devices, you can then, adapt the wire lenght to your need.
• Standard:  Board itself with connectors already soldered, no Midi wire and socket

This product is no longer available.